Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 891

Configurable Data
RIPv6 Admin Mode - Select enable or disable from the pulldown menu. If you select enable RIPv6
will be enabled for the switch. The default is disable.
Split Horizon Mode - Select none, simple or poison reverse from the pulldown menu. Split horizon
is a technique for avoiding problems caused by including routes in updates sent to the router from
which the route was originally learned. The options are:
None - no special processing for this case.
Simple - a route will not be included in updates sent to the router from which it was learned.
Poisoned reverse
learned, but the metric will be set to infinity.
The default is simple.
Update Time - Configure the Ripng update time.
Garbage Time - Configure the Ripng garbage time.
Timeout Time - Configure the Ripng timeout time.
Distance - Configure the Ripng distance.
Default Information Originate - Enable or Disable Default Route Advertise.
Default Metric - Sets a default for the metric of redistributed routes.This field displays the default
metric if one has already been set or blank if not configured earlier. The valid values are 1 to 15.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
11.6.9.2 Configuring RIPv6 Interface Configuration Page
Selection Criteria
Slot/Port - Select the interface for which data is to be configured.
Configurable Data
Interface Mode - Select enable or disable from the pulldown menu. Before you enable RIPv6
version 1 or version 1c on an interface, you must first enable network directed broadcast mode on
the corresponding interface. The default value is disabled.
Passive Interface - Select enable or disable from the pulldown menu. The default value is disabled.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
-
a route will be included in updates sent to the router from which it was
- 891 -