Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 852

11.5.2.2 Configuring RADIUS Server Configuration Page
Selection Criteria
RADIUS Server IP Address - Selects the RADIUS server to be configured. Select add to add a
server.
Primary Server - Sets the selected server to thePrimary or Secondary server.
Message Authenticator - Enable or disable the message authenticator attribute for the selected
server.
Configurable Data
IP Address - The IP address of the server being added.
You cannot define these IP addresses:
0.0.0.0
255.255.255.255
224.xxx.xxx.xxx
127.0.0.1
Host Name -The host name of the server being added.
Port - The UDP port used by this server. The valid range is 0 - 65535.
Secret - The shared secret for this server. This is an input field only.
Apply - The Secret will only be applied if this box is checked. If the box is not checked, anything
entered in the Secret field will have no affect and will not be retained. This field is only displayed if
the user has READWRITE access.
Encrypted - When the secret string is encrypted, this box need to be checked. This field is only
displayed if the user has READWRITE access.
Non-Configurable Data
Current - Indicates if this server is currently in use as the authentication server.
Secret Configured - Indicates if the shared secret for this server has been configured.
Command Buttons
Submit - Sends the updated screen to the switch and causes the changes to take effect on the
switch but these changes will not be retained across a power cycle unless a save is performed.
Remove - Remove the selected server from the configuration. This button is only available to
READWRITE users. These changes will not be retained across a power cycle unless a save is
performed.
- 852 -