Igmp Proxy Commands - Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual

no - This command is used to disable the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).
Default Setting
None
Command Mode
Global Config
9.6.2.12 ip pimsm ssm default
Use this command to define the Source Specific Multicast (SSM) range of IP multicast addresses.
Syntax
ip pimsm ssm {default | <group-address> <group-mask>}
no ip pimsm ssm
no - This command is used to disable the Source Specific Multicast (SSM) range.
Default Setting
Disabled
Command Mode
Global Config
9.7

IGMP Proxy Commands

The IGMP Proxy is used by IGMP Router (IPv4 system) to enable the system to issue IGMP host
messages on behalf of hosts that the system discovered through standard IGMP router interfaces. With
IGMP Proxy enabled, the system acts as proxy to all the hosts residing on its router interfaces.
9.7.1 Show Commands
9.7.1.1 show ip igmp-proxy
This command displays a summary of the host interface status parameters. It displays the following
parameters only when you enable IGMP Proxy.
Syntax
show ip igmp-proxy
- 532 -