Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 528

9.6.2.3 ip pimsm register-threshold
This command is used to configure the Threshold rate for the RP router to switch to the shortest path.
The rate is specified in Kilobits per second. The possible values are 0 to 2000.
Syntax
ip pimsm register-threshold <0 - 2000>
no ip pimsm register-threshold
<0 - 2000> - This is kilobits per seconds.
no - This command is used to reset the Threshold rate for the RP router to switch to the shortest
path to the default value.
Default Setting
0
Command Mode
Global Config
9.6.2.4 ip pimsm spt-threshold
This command is used to configure the Data Threshold rate for the last-hop router to switch to the
shortest path. The rate is specified in Kilobits per second. The possible values are 1 to 2000.
Syntax
ip pimsm spt-threshold <1 - 2000>
no ip pimsm spt-threshold
<1 - 2000> - This is kilobits per seconds.
no - This command is used to reset the Data Threshold rate for the last-hop router to switch to the
shortest path to the default value.
Default Setting
0
Command Mode
Global Config
9.6.2.5 ip pimsm rp-address
This command is used to create RP IP address for the PIM-SM router. The parameter <rp-address> is
the IP address of the RP. The parameter <group-address> is the group address supported by the RP.
- 528 -