Table of Contents
Advertisement
Multicast Router Present Expiration Time - Specify the amount of time you want the switch to wait
to receive a query on an interface before removing it from the list of interfaces with multicast routers
attached. Enter a value between 0 and 3600 seconds. The default is 0 seconds. A value of zero
indicates an infinite timeout, i.e. no expiration.
Command Buttons
Submit - Update the switch with the values you entered. If you want the switch to retain the new
values across a power cycle you must perform a save. You will only see this button if you have
Read/Write access privileges.
11.3.15.3 Configuring MLD Snooping VLAN Configuration Page
Selection Criteria
VLAN ID - Specifies list of VLAN IDs for which MLD Snooping is enabled.
Fast Leave Admin Mode - Enable or disable the MLD Snooping Fast Leave Mode for the specified
VLAN ID.
Configurable Data
VLAN ID - Appears when "New Entry" is selected in VLAN ID combo box. Specifies VLAN ID for
which pre-configurable Snooping parameters are to be set.
Group Membership Interval - Sets the value for group membership interval of MLD Snooping for
the specified VLAN ID. Valid range is (Maximum Response Time + 1) to 3600.
Maximum Response Time - Sets the value for maximum response time of MLD Snooping for the
specified VLAN ID. Valid range is 1 to (Group Membership Interval - 1).Its value should be less than
group membership interval value.
Multicast Router Expiry Time - Sets the value for multicast router expiry time of MLD Snooping for
the specified VLAN ID. Valid range is 0 to 3600.
None-Configurable Data
Admin Mode - Enable MLD Snooping for the specified VLAN ID.
Command Buttons
Submit - Update the switch with the values you entered.
Delete - Update the switch with the default values.
- 738 -
Advertisement
Table of Contents
