Table of Contents
Advertisement
Outer TPID for CNM - Set Outer TPID for Congestion Notification Message (CNM). The system's
default Outer TPID for CNM is 0. The valid TPID range is 0 to 16777215.
Outer VLAN ID for CNM - Set Outer VLAN ID for Congestion Notification Message (CNM). The
system's default Outer VLAN ID for CNM is 1. The valid VLAN ID range is 1 to 3965.
Outer Packet Priority for CNM - Set Outer Packet Priority for Congestion Notification Message
(CNM). The system's default Outer Packet Priority for CNM is 0. The valid dot1p range is -1 to 7.
Outer Packet CFI for CNM - Set Outer Packet CFI for Congestion Notification Message (CNM). The
system's default Outer Packet CFI for CNM is 0. The valid CFI range is -1 to 1.
Inner Packet Priority for CNM - Set Inner Packet Priority for Congestion Notification Message
(CNM). The system's default Inner Packet Priority for CNM is 0. The valid dot1p range is -1 to 7.
Inner Packet CFI for CNM - Set Inner Packet CFI for Congestion Notification Message (CNM). The
system's default Inner Packet CFI for CNM is 0. The valid CFI range is -1 to 1.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
11.7.4.9 Configuring Congestion Notification (CN) Interface configuration
Selection Criteria
Port - Choose a CN configurable interfaces for setting.
Status - Enable or Disable specific priority queue. The CN function is disabled by default on all
priorities for each port.
Non-Configurable Data
Queue ID - Specifies the queue ID.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
- 925 -
Advertisement
Table of Contents
