Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 190

7.3.11 DHCPv6 Client Commands
7.3.11.1 ipv6 address protocol
This command specifies the network of IPv6 configuration protocol to be used . If you modify this value,
the change is effective immediately.
Syntax
ipv6 address protocol {dhcp6 | none}
<dhcp6> - Obtains IPv6 address from DHCPv6.
<none> - Obtains IPv6 address by setting configuration.
Default Setting
None
Command Mode
Interface-Vlan Config
7.3.11.2 ipv6 dhcp restart
This command is used to initiate a DHCPv6 client request by the network interface.
Syntax
ipv6 dhcp6 restart
Default Setting
None
Command Mode
Global Config
7.3.11.3 serviceport protocol
This command specifies the oob configuration protocol to be used. If you modify this value, the change is
effective immediately.
Syntax
serviceport protocol {bootp | dhcp | dhcp6 | none [dhcp6]}
- 190 -