Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 179

SNMP Trap Name: The community string of the SNMP trap packet sent to the trap manager. This
may be up to 16 alphanumeric characters. This string is case sensitive.
IP Address: The IP address to receive SNMP traps from this device. Enter 4 numbers between 0
and 255 separated by periods.
SNMP Version: The trap version to be used by the receiver.
SNMP v1 – Uses SNMP v1 to send traps to the receiver.
SNMP v2 – Uses SNMP v2 to send traps to the receiver.
Status: A pull down menu that indicates the receiver's status (enabled or disabled) and allows the
administrator/user to perform actions on this user entry:
Enable: send traps to the receiver.
Disable: do not send traps to the receiver.
Delete: remove the table entry.
7.3.6.2 snmptrap snmpversion
This command configures the version for snmp trap.
Syntax
snmptrap snmpversion <name> <ipaddr> <snmpversion>
Default Setting
Snmpv2
Command Mode
Global Config
7.3.6.3 snmp trap link-status
This command enables link status traps by interface.
This command is valid only when the Link Up/Down Flag is enabled. See 'snmpserver
i
enable traps linkmode' command.
Syntax
snmp trap link-status
no snmp trap link-status
no - This command disables link status traps by interface.
- 179 -