Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 792

Non-Configurable Data
Active State - The state of the specified interface is either Active or Inactive. An interface is
considered active if it the link is up and it is in forwarding state.
MAC Address - The burned-in physical address of the specified interface. The format is six two-digit
hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
Link Speed Data Rate - An integer representing the physical link data rate of the specified interface.
This data is valid only for physical interfaces and is measured in Megabits per second (Mbps).
Command Buttons
Submit - Update the switch with the values on this screen. If you want the switch to retain the new
values across a power cycle, you must perform a save.
Delete IP Address - Delete the IP Address from the interface. Note that the address can not be
deleted if there are secondary addresses configured.
Secondary IP Address - Proceed to the Secondary IP Address configuration screen.
11.4.3 Managing OSPF
11.4.3.1 Configuring OSPF
- 792 -