Table of Contents
Advertisement
Install the cable management arm
1.
Slide
the device part way out of the rack to provide
management
arm.
2. Attach the
inner member connector
looking at the front of the device).
3. Attach the
supporting bar connector
4. Attach the
supporting bar connector
5. Attach the
outer member connecter
6. Plug the
supplied power cables
into the power supplies on the back of the device,
and connect any other
required
cables.
14
space
for installing the
cable
to the back end of the
right inner rail
(when
to the back end of the
right middle
rail.
to the back end of the
left middle
rail.
to the back end of the
left outer
rail.
7. Open the
red caps
and route the cables through the
ensure that cables are
not damaged
when sliding the device
8. Fasten the cables using the provided
Use
two straps
on each
joint
and one on each connector.
9.
Slide
the chassis
in and out
to ensure that the cable management arm's motion is
smooth. If it is not, loosen the straps as required.
10. If required, adjust the location of the
U bracket
with the
power
source.
Connect the device
1. Plug the
power cables
into
grounded electrical outlets
such as uninterruptible power supplies (UPS) or a power distribution units (PDU).
2. Insert the
Ethernet cable
into a router or switch that is connected to the Internet.
3. Press the
power button
on the system to
Note:
For
additional
security, secure the
with the provided
M5 20L Truss Head
screws.
wire
carrier. This is important to
in and out
of the rack.
straps
and the
aluminum joints
and
U
bracket.
to ensure that it does not interfere
or
separate power
sources,
turn on
the device.
chassis handles
to the front of the rack
15
Advertisement
Table of Contents
