Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 927

Configurable Data
Admin Mode - Select enable or disable from the dropdown menu. This sets the administrative status
of DVMRP to active or inactive. The default is disable.
Non-Configurable Data
Version - The current value of the DVMRP version string.
Total Number of Routes - The number of routes in the DVMRP routing table.
Reachable Routes - The number of routes in the DVMRP routing table that have a non-infinite
metric.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
11.8.1.2 Configuring DVMRP Interface Configuration Page
Selection Criteria
Slot/Port - Select the interface for which data is to be configured. You must configure at least one
router interface before you configure a DVMRP interface. Otherwise you will see a message telling
you that no router interfaces are available, and the configuration screen will not be displayed.
Configurable Data
Interface Mode - Select enable or disable from the pull-down menu to set the administrative mode of
the selected DVMRP routing interface.
Interface Metric - Enter the DVMRP metric for the selected interface. This value is sent in DVMRP
messages as the cost to reach this network. Valid values are from (1 to 31).
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
- 927 -