Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 201

7.3.14.6 serviceport ipv6 address
Use this command to configure IPv6 global addressing (i.e. Default routers) information for the service
port.
Syntax
serviceport ipv6 address <address>/<prefix-length> [eui64]
no serviceport ipv6 address [<address>/<prefix-length>]
no - This command remove all IPv6 prefixes on the service port interface.
<address>: IPv6 prefix in IPv6 global address format.
<prefix-length>: IPv6 prefix length value.
[eui64]: Formulate IPv6 address in eui64 address format.
Multiple IPv6 prefixes can be configured for the service port.
i
Default Setting
None
Command Mode
Global Config
7.3.14.7 serviceport ipv6 gateway
Use this command to configure IPv6 gateway (i.e. Default routers) information for the service port.
Syntax
serviceport ipv6 gateway <gateway-address>
no serviceport ipv6 gateway
<gateway-address>: Gateway address in IPv6 global or link-local address format.
no - This command remove IPv6 gateways on the service port interface.
Only a single IPv6 gateway address can be configured for the service port. There may be a
i
combination of IPv6 prefixes and gateways that are explicitly configured and those that are
set through auto-address configuration with a connected IPv6 router on their service port
interface.
- 201 -