Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 130

Command Mode
Interface Config
This command enables unicast storm recovery mode on all interfaces.
Syntax
storm-control unicast
no storm-control unicast
no - This command disables unicast storm recovery mode on all interfaces.
Default Setting
None
Command Mode
Global Config
7.2.11.5 switchport broadcast packet-rate
This command will protect your network from broadcast storms by setting a threshold level for broadcast
traffic on each port.
Syntax
switchport broadcast packet-rate {1 | 2 | 3 | 4}
1 - Threshold level represents 64 pps for 1G Port or 1042 pps for 10G port.
2 - Threshold level represents 128 pps for 1G Port or 2084 pps for 10G port.
3 - Threshold level represents 256 pps for 1G Port or 3124 pps for 10G port.
4 - Threshold level represents 512 pps for 1G Port or 4167 pps for 10G port.
Note: pps (packet per second)
Default Setting
Level 4
Command Mode
Interface Config
- 130 -