Ipv6 Routing Commands - Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual

interface loopback <0-7>
no interface loopback <0-7>
no - This command removes the loopback interface and associated configuration parameters for the
specified loopback interface.
Default Setting
Disabled
Command Mode
Global Config
10.3

IPv6 Routing Commands

This section describes the IPv6 commands you use to configure IPv6 on the system and on the
interfaces. This section also describes IPv6 management commands and show commands.
10.3.1 Show Commands
10.3.1.1 show ipv6 brief
This command displays the IPv6 status of forwarding mode and IPv6 unicast routing mode.
Syntax
show ipv6 brief
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
IPv6 Forwarding Mode: Shows whether the IPv6 forwarding mode is enabled.
IPv6 Unicast Routing Mode: Shows whether the IPv6 unicast routing mode is enabled.
IPv6 Hop Limit：Shows the unicast hop count used in IPv6 packets originated by the node. For
more information, see "ipv6 hot-limit"
ICMPv6 Rate Limit Error Interval：Shows how often the token bucket is initialized with burst-size
tokens. For more information, see "ipv6 icmp error-interval"
- 546 -