Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 112

Hide thumbs Also See for FortiSwitch-548B v. 5.2.0.2:
Table of Contents

Advertisement

participate in querier election where in the least ip address will win the querier election and operates
as the querier in that VLAN. The other querier moves to non-querier state.
Querier Election Participation Mode: Displays the querier election participate mode on the VLAN.
When this mode is disabled, up on seeing a query of the same version in the vlan, the snooping
querier move to non querier state. Only when this mode is enabled, the snooping querier will
participate in querier election where in the least ip address will win the querier election and operates
as the querier in that VLAN. The other querier moves to non-querier state.
Querier Vlan Address: Displays the Snooping Querier Address to be used as source address in
periodic MLD queries sent on the specified VLAN.
Operational State: Specifies the operational state of the MLD Snooping Querier on a VLAN.
Operational Version: Displays the operational MLD protocol version of the querier.
7.2.9.3
show ipv6 mld snooping querier detail
This command display all of MLD snooping querier information on the system.
Syntax
show ipv6 mld snooping querier detail
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
MLD Snooping Querier Mode: Administrative mode for MLD Snooping. The default is disable
Querier Address: Specify the Snooping Querier Address to be used as source address in periodic
MLD queries. This address is used when no address is configured on the VLAN on which query is
being sent.
MLD Version: Specify the MLD protocol version used in periodic IGMP queries.
Querier Query Interval: Specify the time interval in seconds between periodic queries sent by the
snooping querier. The Query Interval must be a value in the range of 1 and 1800. The default value
is 60.
Querier Expiry Interval: Specify the time interval in seconds after which the last querier information
is removed. The Querier Expiry Interval must be a value in the range of 60 and 300. The default
value is 60.
- 112 -

Advertisement

Table of Contents
loading

Table of Contents