Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 580

10.4.2.3 ipv6 ospf cost
This command configures the cost on an OSPF interface. The <cost> parameter has a range of 1 to
65535.
Syntax
ipv6 ospf cost <1-65535>
no ipv6 ospf cost
<no> - This command configures the default cost on an OSPF interface.
Default Setting
None
Command Mode
Interface Config
10.4.2.4 ipv6 ospf dead-interval
This command sets the OSPF dead interval for the specified interface. The value for <seconds> is a
valid positive integer, which represents the length of time in seconds that a router's Hello packets have
not been seen before its neighbor routers declare that the router is down. The value for the length of time
must be the same for all routers attached to a common network. This value should be some multiple of
the Hello Interval (i.e. 4). Valid values range for <seconds> is from 1 to 2147483647.
Syntax
ipv6 ospf dead-interval <seconds>
no ipv6 ospf dead-interval
<no> - This command sets the default OSPF dead interval for the specified interface.
Default Setting
40
Command Mode
Interface Config
10.4.2.5 ipv6 ospf hello-interval
This command sets the OSPF hello interval for the specified interface. The value for <seconds> is a
valid positive integer, which represents the length of time in seconds. The value for the length of time
- 580 -