Fortinet FortiSwitch-548B v. 5.2.0.2 Administration Manual page 18

show loginsession
username <username> {passwd |
nopasswd}
copy running-config startup-config
[filename]
3.5.4 Quick Start up IP Address
To view the network parameters the operator can access the device by the following three methods.

Simple Network Management Protocol - SNMP

Telnet

Web Browser
Table 2-4. Quick Start up IP Address
Command
show ip interface
(Read/Write) or is only able to view (Read
Only).
As a factory default, admin has Read/Write
access and guest has Read Only access.
There can only be one Read/Write user and
up to 5 Read Only users.
Displays all login session information
Allows the user to set passwords or change
passwords needed to login
A prompt will appear after the command is
entered requesting the old password. In the
absence of an old password leave the area
blank. The operator must press enter to
execute the command.
The system then prompts the user for a new
password then a prompt to confirm the new
password. If the new password and the
confirmed password match a message will be
displayed.
The user password should not be more than
eight characters in length.
This will save passwords and all other
changes to the device.
If you do not save config, all configurations will
be lost when a power cycle is performed on
the switch or when the switch is reset.
Details
Displays the Network Configurations
IP Address - IP Address of the interface
Default IP is 192.168.2.1
Subnet Mask - IP Subnet Mask for the
interface. Default is 255.255.255.0
Default Gateway - The default Gateway for
this interface
Default value is 0.0.0.0
Burned in MAC Address - The Burned in MAC
Address used for inband connectivity
Network Configurations Protocol Current -
Indicates which network protocol is being
used. Default is none
- 18 -