Save The Running-Configuration - Dell Force10 C150 Configuration Manual

usbflash
• The
to the FTOS Release Notes for a list of approved USB vendors.
Figure 3-4
Figure 3-4. Saving a file to a Remote System
FTOS#copy flash://FTOS-EF-8.2.1.0.bin ftp://myusername:mypassword@10.10.10.10//FTOS/FTOS-EF-8.2.1.0
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
27952672 bytes successfully copied
Figure 3-5
an FTP server.
Figure 3-5. Saving a file to a Remote System
core1#$//copy ftp://myusername:mypassword@10.10.10.10//FTOS/FTOS-EF-8.2.1.0.bin flash://
Destination file name [FTOS-EF-8.2.1.0.bin.bin]:
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
26292881 bytes successfully copied

Save the Running-configuration

The running-configuration contains the current system configuration. Dell Force10 recommends that you
copy your running-configuration to the startup-configuration. The system uses the startup-configuration
during boot-up to configure the system. The startup-configuration is stored in the internal flash on the
primary RPM by default, but it can be saved onto an external flash (on an RPM) or a remote server.
To save the running-configuration:
Note: The commands in this section follow the same format as those in
System on page 51
commands assume that current directory is the internal flash, which is the system default.
52 | Getting Started
rpm0usbflash
and
shows an example of using the
Local Location
shows an example of using the
Remote Location
but use the filenames startup-configuration and running-configuration. These
commands are supported on E-Series ExaScale platform only. Refer
copy
command to save a file to an FTP server.
Remote Location
copy
command to import a file to the Dell Force10 system from
Local Location
Copy Files to and from the