Enable Cfm Snmp Traps - Dell Force10 C150 Configuration Manual

Task
FTOS#show ethernet cfm traceroute-cache
Traceroute to 00:01:e8:52:4a:f8 on Domain Customer2, Level 7, MA name Test2 with
VLAN 2
------------------------------------------------------------------------------
Hops
------------------------------------------------------------------------------
4 00:00:00:01:e8:53:4a:f8
00:00:00:01:e8:52:4a:f8
Delete all Link Trace Cache entries.

Enable CFM SNMP Traps.

Task
Enable SNMP trap messages for
Ethernet CFM.
A Trap is sent only when one of the five highest priority defects occur, as shown in
Table 5-2. ECFM SNMP Traps
Cross-connect defect
Error-CCM defect
MAC Status defect
Remote CCM defect
RDI defect
90 | 802.1ag
Command Syntax
Host
Next Host
clear ethernet cfm traceroute-cache
Command Syntax
snmp-server enable traps ecfm
%ECFM-5-ECFM_XCON_ALARM: Cross connect fault detected by MEP 1 in Domain customer1
at Level 7 VLAN 1000
%ECFM-5-ECFM_ERROR_ALARM: Error CCM Defect detected by MEP 1 in Domain customer1
at Level 7 VLAN 1000
%ECFM-5-ECFM_MAC_STATUS_ALARM: MAC Status Defect detected by MEP 1 in Domain
provider at Level 4 VLAN 3000
%ECFM-5-ECFM_REMOTE_ALARM: Remote CCM Defect detected by MEP 3 in Domain customer1
at Level 7 VLAN 1000
%ECFM-5-ECFM_RDI_ALARM: RDI Defect detected by MEP 3 in Domain customer1 at Level
7 VLAN 1000
IngressMAC Ingr Action
Egress MAC Egress Action
00:01:e8:52:4a:f8
Command Mode
Relay Action
FWD Status
IngOK
Terminal MEP
EXEC Privilege
Command Mode
CONFIGURATION
Table 5-2.
RlyHit