Dell Force10 C150 Configuration Manual page 39

Table 2-1. FTOS Command Modes
CLI Command Mode
STANDARD ACCESS-
LIST
EXTENDED ACCESS-
LIST
MULTIPLE
SPANNING TREE
Per-VLAN SPANNING
TREE Plus
PREFIX-LIST
RAPID SPANNING
TREE
REDIRECT
ROUTE-MAP
ROUTER BGP
ROUTER ISIS
ROUTER OSPF
ROUTER RIP
SPANNING TREE
TRACE-LIST
Figure 2-3 illustrates how to change the command mode from CONFIGURATION mode to PROTOCOL
SPANNING TREE.
Figure 2-3. Changing CLI Modes
FTOS(conf)#protocol spanning-tree 0
FTOS(config-span)#
Prompt
FTOS(config-std-macl)#
FTOS(config-ext-macl)#
FTOS(config-mstp)#
FTOS(config-pvst)#
FTOS(conf-nprefixl)#
FTOS(config-rstp)#
FTOS(conf-redirect-list)#
FTOS(config-route-map)#
FTOS(conf-router_bgp)#
FTOS(conf-router_isis)#
FTOS(conf-router_ospf)#
FTOS(conf-router_rip)#
FTOS(config-span)#
FTOS(conf-trace-acl)#
New command prompt
Access Command
mac access-list standard
mac access-list extended
protocol spanning-tree mstp
protocol spanning-tree pvst
ip prefix-list
protocol spanning-tree rstp
ip redirect-list
route-map
router bgp
router isis
router ospf
router rip
protocol spanning-tree 0
ip trace-list
Configuration Fundamentals | 39