Dell Force10 C150 Configuration Manual page 213

• AS_CONFED_SEQUENCE has a path length of 1, no matter how many ASs are in the
AS_CONFED_SEQUENCE.
5. Prefer the path with the lowest ORIGIN type (IGP is lower than EGP, and EGP is lower than
INCOMPLETE).
6. Prefer the path with the lowest Multi-Exit Discriminator (MED) attribute. The following criteria apply:
• This comparison is only done if the first (neighboring) AS is the same in the two paths; the MEDs
are compared only if the first AS in the AS_SEQUENCE is the same for both paths.
bgp always-compare-med
• If the
• Paths with no MED are treated as "worst" and assigned a MED of 4294967295.
7. Prefer external (EBGP) to internal (IBGP) paths or confederation EBGP paths.
8. Prefer the path with the lowest IGP metric to the BGP next-hop.
9. FTOS deems the paths as equal and does not perform steps 9 through 11 listed below, if the following
criteria is met:
• the IBGP multipath or EBGP multipath are configured (
• the paths being compared were received from the same AS with the same number of ASs in the AS
Path but with different NextHops
• the paths were received from IBGP or EBGP neighbor respectively
bgp bestpath router-id ignore
10. If the
• If the Router-ID is the same for multiple paths (because the routes were received from the same
route) skip this step.
• If the Router-ID is NOT the same for multiple paths, Prefer the path that was first received as the
Best Path. The path selection algorithm should return without performing any of the checks
outlined below.
11. Prefer the path originated from the BGP router with the lowest router ID. For paths containing a Route
Reflector (RR) attribute, the originator ID is substituted for the router ID.
12. If two paths have the same router ID, prefer the path with the lowest cluster ID length. Paths without a
cluster ID length are set to a 0 cluster ID length.
13. Prefer the path originated from the neighbor with the lowest address. (The neighbor address is used in
the BGP neighbor configuration, and corresponds to the remote peer used in the TCP connection with
the local router.)
After a number of best paths is determined, this selection criteria is applied to group's best to determine the
ultimate best path.
In non-deterministic mode (the
the order in which they arrive. This method can lead to FTOS choosing different best paths from a set of
paths, depending on the order in which they were received from the neighbors since MED may or may not
get compared between adjacent paths. In deterministic mode, FTOS compares MED between adjacent
paths within an AS group since all paths in the AS group are from the same AS.
command is entered, MEDs are compared for all paths.
command is enabled and:
bgp non-deterministic-med
maximum-path
command)
command is applied), paths are compared in
Border Gateway Protocol IPv4 (BGPv4) | 213