Dell Force10 C150 Configuration Manual page 113

To enable 802.1X:
Step Task
1 Enable 802.1X globally.
2 Enter INTERFACE mode on an interface or a range of
interfaces.
3 Enable 802.1X on an interface or a range of interfaces.
Verify that 802.1X is enabled globally and at interface level using the command
dot1x
from EXEC Privilege mode, as shown in
Figure 7-5. Verifying 802.1X Global Configuration
FTOS#show running-config | find dot1x
dot1x authentication
!
[output omitted]
!
interface GigabitEthernet 2/1
ip address 2.2.2.2/24
dot1x authentication
no shutdown
!
interface GigabitEthernet 2/2
ip address 1.0.0.1/24
dot1x authentication
no shutdown
--More--
View 802.1X configuration information for an interface using the command
shown in Figure
Figure 7-6. Verifying 802.1X Interface Configuration
FTOS#show dot1x interface gigabitethernet 2/1
802.1x information on Gi 2/1:
-----------------------------
Dot1x Status:
Port Control:
Port Auth Status:
Re-Authentication:
Untagged VLAN id:
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Auth Type:
Auth PAE State:
Backend State:
7-6.
Enable
AUTO
UNAUTHORIZED
Disable
None
30 seconds
60 seconds
2
30 seconds
30 seconds
3600 seconds
2
SINGLE_HOST
Initialize
Initialize
Command Syntax
dot1x authentication
interface range
[
dot1x authentication
Figure 7-5.
802.1X Enabled
802.1X Enabled on
802.1X Enabled on Interface
All ports unauthorized by default
Command Mode
CONFIGURATION
] INTERFACE
INTERFACE
show running-config | find
show dot1x interface
, as
802.1X | 113