Configure A Route Map For Route Tagging; Continue Clause - Dell Force10 C150 Configuration Manual

router ospf 34
default-information originate metric-type 1
redistribute static metric 20 metric-type 2 tag 0 route-map staticospf
!
route-map staticospf permit 10
match interface GigabitEthernet 0/0
match metric 255
set level backbone

Configure a route map for route tagging

One method for identifying routes from different routing protocols is to assign a tag to routes from that
protocol. As the route enters a different routing domain, it is tagged and that tag is passed along with the
route as it passes through different routing protocols. This tag can then be used when the route leaves a
routing domain to redistribute those routes again.
redistribute ospf
In Figure 8-26, the
apply a tag of 34 to all internal OSPF routes that are redistributed into RIP.
Figure 8-26. Tagging OSPF Routes Entering a RIP Routing Domain
!
router rip
redistribute ospf 34 metric 1 route-map torip
!
route-map torip permit 10
match route-type internal
set tag 34
!

Continue clause

Normally, when a match is found, set clauses are executed, and the packet is then forwarded; no more
route-map modules are processed. If the
module (or a specified module) is processed even after a match is found.
clause at the end of a route-map module. In this example, if a match is found in the route-map "test"
module 10, module 30 will be processed.
Note: If the continue clause is configured without specifying a module, the next sequential module is
processed.
command with a route map is used in the ROUTER RIP mode to
continue
command is configured at the end of a module, the next
IP Access Control Lists (ACL), Prefix Lists, and Route-maps | 167
Figure 8-27 shows a continue