Dell Force10 C150 Configuration Manual page 188

• The neighbor inherits only the global timer values that are configured with the
command (interval, min_rx, and multiplier).
If you explicitly enable (or disable) a peer group for BFD that has no BFD parameters configured (e.g.
advertisement interval) using the
BFD settings configured with the
Displaying BFD for BGP Information
To display information about BFD for BGP sessions on a router, enter one of the following
commands:
Task
Verify a BFD for BGP configuration.
Verify that a BFD for BGP session has been
successfully established with a BGP neighbor. A
line-by-line listing of established BFD
adjacencies is displayed.
Display BFD packet counters for sessions with
BGP neighbors.
Check to see if BFD is enabled for BGP
connections.
Displays routing information exchanged with
BGP neighbors, including BFD for BGP
sessions.
188 | Bidirectional Forwarding Detection
neighbor
peer-group-name
bfd all-neighbors
command.
Command
show running-config bgp
Figure 9-14
show bfd neighbors [interface] [detail]
Figure 9-15 and Figure 9-16
show bfd counters bgp [interface]
Figure 9-17
show ip bgp summary
Figure 9-18
show ip bgp neighbors [ip-address]
Figure 9-19
bfd all-neighbors
bfd
command, the peer group inherits any
Command Mode
EXEC Privilege
EXEC Privilege
EXEC Privilege
EXEC Privilege
EXEC Privilege
show