Ip Fragments Acl Examples; Layer 4 Acl Rules Examples - Dell Force10 C150 Configuration Manual

• Second and subsequent fragments are allowed because a Layer 4 rule cannot be applied to these
fragments. If the packet is to be denied eventually, the first fragment would be denied and hence the
packet as a whole cannot be reassembled.
• Implementing the required rules will use a significant number of CAM entries per TCP/UDP entry.
• For IP ACL, FTOS always applies implicit deny. You do not have to configure it.
• For IP ACL, FTOS applies implicit permit for second and subsequent fragment just prior to the
implicit deny.
• If an explicit deny is configured, the second and subsequent fragments will not hit the implicit permit
rule for fragments.
• Loopback interfaces do not support ACLs using the IP fragment option. If you configure an ACL with
the fragments option and apply it to a loopback interface, the command is accepted, but the ACL
entries are not actually installed the offending rule in CAM.

IP fragments ACL examples

The following configuration permits all packets (both fragmented & non-fragmented) with destination IP
10.1.1.1. The second rule does not get hit at all.
FTOS(conf)#ip access-list extended ABC
FTOS(conf-ext-nacl)#permit ip any 10.1.1.1/32
FTOS(conf-ext-nacl)#deny ip any 10.1.1.1./32 fragments
FTOS(conf-ext-nacl)
To deny second/subsequent fragments, use the same rules in a different order. These ACLs deny all second
& subsequent fragments with destination IP 10.1.1.1 but permit the first fragment & non fragmented
packets with destination IP 10.1.1.1 .
FTOS(conf)#ip access-list extended ABC
FTOS(conf-ext-nacl)#deny ip any 10.1.1.1/32 fragments
FTOS(conf-ext-nacl)#permit ip any 10.1.1.1/32
FTOS(conf-ext-nacl)

Layer 4 ACL rules examples

In the below scenario, first fragments non-fragmented TCP packets from 10.1.1.1 with TCP destination
port equal to 24 are permitted. All other fragments are denied.
FTOS(conf)#ip access-list extended ABC
FTOS(conf-ext-nacl)#permit tcp host 10.1.1.1 any eq 24
FTOS(conf-ext-nacl)#deny ip any any fragment
FTOS(conf-ext-nacl)
IP Access Control Lists (ACL), Prefix Lists, and Route-maps | 139