Dell Force10 C150 Configuration Manual page 186

Note that the sample configuration shows alternative ways to establish a BFD session with a BGP
neighbor:
• By establishing BFD sessions with all neighbors discovered by BGP (
• By establishing a BFD session with a specified BGP neighbor (
bfd
command)
BFD packets originating from a router are assigned to the highest priority egress queue to minimize
transmission delays. Incoming BFD control packets received from the BGP neighbor are assigned to the
highest priority queue within the Control Plane Policing (COPP) framework to avoid BFD packets drops
due to queue congestion.
BFD notifies BGP of any failure conditions that it detects on the link. Recovery actions are initiated by
BGP.
BFD for BGP is supported only on directly-connected BGP neighbors and only in BGP IPv4 networks.
• On an E-Series TeraScale or C-Series router, up to 100 simultaneous BFD sessions are supported per
line card.
• On an S4810 router, up to 64 simultaneous BFD sessions are supported.
As long as each BFD for BGP neighbor receives a BFD control packet within the configured BFD interval
for failure detection, the BFD session remains up and BGP maintains its adjacencies. If a BFD for BGP
neighbor does not receive a control packet within the detection interval, the router informs any clients of
the BFD session (other routing protocols) about the failure. It then depends on the individual routing
protocols that uses the BGP link to determine the appropriate response to the failure condition. The typical
response is usually to terminate the peering session for the routing protocol and reconverge by bypassing
the failed neighboring router. A log message is generated whenever BFD detects a failure condition.
You can configure BFD for BGP on the following types of interfaces: physical port (10GE or 40GE), port
channel, and VLAN.
To establish a BFD session with one or all BGP neighbors, follow these steps:
Step Task
1 Enable BFD globally.
2 Specify the AS number and enter ROUTER
BGP configuration mode.
3 Add a BGP neighbor or peer group in a
remote AS.
4 Enable the BGP neighbor.
186 | Bidirectional Forwarding Detection
neighbor {ip-address | peer-group-name}
Command Syntax
bfd enable
router bgp
as-number
neighbor {
|
ip-address peer-group
} remote-as as-
name number
neighbor {
ip-address |
} no shutdown
peer-group-name
bfd all-neighbors
command)
Command Mode
CONFIGURATION
CONFIGURATION
CONFIG-ROUTER-
BGP
CONFIG-ROUTER-
BGP