Ip Prefix Lists; Implementation Information; Configuration Task List For Prefix Lists - Dell Force10 C150 Configuration Manual

Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs Also See for Force10 C150:
Table of Contents

Advertisement

IP Prefix Lists

Prefix Lists
are supported on platforms:
IP prefix lists control routing policy. An IP prefix list is a series of sequential filters that contain a matching
criterion (examine IP route prefix) and an action (permit or deny) to process routes. The filters are
processed in sequence so that if a route prefix does not match the criterion in the first filter, the second
filter (if configured) is applied. When the route prefix matches a filter, FTOS drops or forwards the packet
based on the filter's designated action. If the route prefix does not match any of the filters in the prefix list,
the route is dropped (that is, implicit deny).
A route prefix is an IP address pattern that matches on bits within the IP address. The format of a route
prefix is A.B.C.D/X where A.B.C.D is a dotted-decimal address and /X is the number of bits that should be
matched of the dotted decimal address. For example, in 112.24.0.0/16, the first 16 bits of the address
112.24.0.0 match all addresses between 112.24.0.0 to 112.24.255.255.
Below are some examples that permit or deny filters for specific routes using the
where x.x.x.x/x represents a route prefix:
To deny only /8 prefixes, enter deny x.x.x.x/x ge 8 le 8
To permit routes with the mask greater than /8 but less than /12, enter permit x.x.x.x/x ge 8
le 12
To deny routes with a mask less than /24, enter deny x.x.x.x/x le 24
To permit routes with a mask greater than /20, enter permit x.x.x.x/x ge 20
The following rules apply to prefix lists:
A prefix list without any permit or deny filters allows all routes.
An "implicit deny" is assumed (that is, the route is dropped) for all route prefixes that do not match a
permit or deny filter in a configured prefix list.
Once a route matches a filter, the filter's action is applied. No additional filters are applied to the route.

Implementation Information

In FTOS, prefix lists are used in processing routes for routing protocols (for example, RIP, OSPF, and
BGP).
Note: The S-Series platform does not support all protocols. It is important to know which protocol you are
supporting prior to implementing Prefix-Lists.

Configuration Task List for Prefix Lists

To configure a prefix list, you must use commands in the PREFIX LIST, the ROUTER RIP, ROUTER
OSPF, and ROUTER BGP modes. Basically, you create the prefix list in the PREFIX LIST mode, and
assign that list to commands in the ROUTER RIP, ROUTER OSPF and ROUTER BGP modes.
c e s
IP Access Control Lists (ACL), Prefix Lists, and Route-maps | 153
le
ge
and
parameters,

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents