Dell Force10 C150 Configuration Manual page 78

Very similar to the options of the
CONFIGURATION mode on
startup configuration file, are stored in NVRAM and are then used routinely:
Task
Configure the system to routinely boot from the
designated location.
rpm0
After entering
keywords and then the
You can use the command for each of the
combinations of RPM and option.
Also, because the C-Series and E-Series can boot from an external flash, you can recover from a failed
boot image on the flash by simply fixing that source. For details on boot code and FTOS setup, see the
FTOS Release Notes for the specific FTOS versions that you want to use.
The network boot facility has only become available on the S-Series with FTOS 7.8.1.0 and its
accompanying boot code. In addition to installing FTOS 7.8.1.0, you must separately install that new boot
code. For installation details, see the S-Series and FTOS Release Notes for Version 7.8.1.0.
78 | System Management
boot change
the C-Series and E-Series to set the boot parameters that, when saved to the
rpm1
or , enter one of the three
file-url.
boot system
command, the
Command Syntax
boot system { rpm0 | rpm1 } ( default |
primary | secondary } file-url
file-url, to
For boot from a file:
• on the internal Flash, enter
followed by the filename.
ftp://
• on an FTP server, enter
user:password hostip/filepath
@
• on the external Flash, enter
followed by the filename.
on a TFTP server, enter tftp:// hostip/
•
filepath
command is available in
Command Mode
CONFIGURATION
flash://
slot0://