Getting Started - Dell Force10 C150 Configuration Manual

Getting Started

This chapter contains the following major sections:
• Default Configuration on page 46
• Configure a Host Name on page 47
• Access the System Remotely on page 47
• Configure the Enable Password on page 50
• Configuration File Management on page 50
• File System Management on page 55
When you power up the chassis, the system performs a Power-On Self Test (POST) during which Route
Processor Module (RPM), Switch Fabric Module (SFM), and line card status LEDs blink green.The
system then loads FTOS and boot messages scroll up the terminal window during this process. No user
interaction is required if the boot process proceeds without interruption.
When the boot process is complete, the RPM and line card status LEDs remain online (green), and the
console monitor displays the Force10 banner and EXEC mode prompt, as shown in
For details on using the Command Line Interface (CLI), see the
Chapter 1, Configuration Fundamentals, on page
Accessing the Command Line
47.
3
Figure 3-1.
section in
Getting Started | 45