Enabling The Via Address Support (Optional); Override The Default Destination Call Signaling Port (Optional) - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide

Enabling the via address support (optional)

Some LAN Voice applications require the H.323 gateway to add the calling party number of the connected
terminal as an H.323 E.164 Alias to the Facility message when transferring a call to another gateway. This
enables a gatekeeper to detect loops of call forwarding and to stop them.
Procedure: To enable sending of the via address in call transfers
Mode: Interface H.323
Step
1
node (if-h323)[ if-name ]#via-addres-sup-
port
Example: Enabling the via address support
The following example shows how to enable the via address support on an H.323 interface named MyH323If.
SN>enable
SN#configure
SN(cfg)#context cs
SN(ctx-cs)[switch]#interface h323 MyH323If
SN(if-h323)[MyH323If]#via-address-support

Override the default destination call signaling port (Optional)

Normally, if no gatekeeper is used, the TCP call-signaling connection for outbound H.323 calls is established
to the H.323 standard call-signaling port 1720. If your destination uses a different call-signaling port, it is pos-
sible to define an alternate port using this procedure.
Note The call-signaling port specified here has no effect, if a gatekeeper is used. In
that case the gatekeeper will provide the portnumber to use for establishing
the call signaling connection
Procedure: To configure an alternate destination TCP call-signaling port
Mode: Interface H.323
Step
1
node ( if-h323 )[ if-name ]# remoteport port Specifies the TCP port to which the call-signal-
Example: Specifying an alternate destination call-signaling port
The following example shows how to set the destination call-signaling port number for the H.323 interface
MyH323If to 2300.
SN>enable
SN#configure
SN(cfg)#context cs
SN(ctx-cs)[switch]#interface h323 MyH323If
SN(if-h323)[MyH323If]#remoteport 2300
H.323 interface configuration task list
Command
Command
31 • H.323 interface configuration
Purpose
Enables sending of the via address in call
transfers (Default: disabled)
Purpose
ing connection should be established.
353