Configure Qosprofile Min-Bps - Extreme Networks ExtremeWare Command Reference Manual

configure qosprofile min-bps

configure qosprofile <qosprofile> min-bps <bps> [k | m]
max-bps <bps> [k | m] {priority <level>} [ports <portlist> |
multilink <multilink name>]
Description
Modifies the default QoS profile parameters for T1 and E1 modules.
Syntax Description
qosprofile
min-bps
k
m
max-bps
level
portlist
multilink name
Default
• Minimum bandwidth—0 Kbps
• Maximum bandwidth—1536 Kbps
• Priority—low
Usage Guidelines
This command sets the software egress QoS for T1 and E1 modules, using units of bps of bandwidth,
instead of percentages of bandwidth.
For WAN QoS only two priority levels are available, low and high. Software queues are scheduled
based on priority, minimum bandwidth, and maximum bandwidth. Only one queue can have high
priority.
The high priority queue is flushed on every scheduling round. Minimum bandwidth is ignored for this
queue. Throughput is policed based on the maximum bandwidth value. Policing prevents packets from
entering a queue that is receiving traffic from the backplane too fast. The remaining bandwidth is
shared by all other queues based on the minimum bandwidth setting of each queue. In other words, the
high priority queue takes up all the bandwidth up to its
share all the remaining bandwidth.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies a QoS profile name.
Specifies a minimum bandwidth for this queue. The default setting is 0.
Specifies Kbps.
Specifies Mbps.
Specifies the maximum bandwidth this queue is permitted to use. The default
setting is 1536 Kbps.
Specifies a service priority setting. Settings are low and high. The default
setting is low. Available in egress mode only.
Specifies a list of ports or slots and ports to which the parameters apply. May
be in the form 1, 2, 3-5, 2:5, 2:6-2:8.
Specifies a multilink.
setting, while the low priority queues
max-bps
configure qosprofile min-bps
1715