Configure Wireless Ports Interface Power-Level - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

Wireless Commands

configure wireless ports interface power-level

configure wireless ports <portlist> interface [1 | 2] power-level <level>

Configures the power-level for the specified interface.

Syntax Description

Usage Guidelines

Each wireless port on the Alpine 3800 contains two interfaces. Interface 1 supports 802.11a, and interface

2 supports 802.11b/g radio signals. The

command allows you to configure one of the two individual interfaces (1|2) on a port or ports. If there

is radio interference from other devices, then you can adjust the power level to an appropriate level

below full power.

The following command configures the power level to half-power for interface 1 on ports 5 to 16:

configure wireless port 5-16 interface 1 power-level half

This command was first available in ExtremeWare 6.2a and added to the "i" series in 7.3.0.

Platform Availability

This command is available on Alpine 3800 series only.

Specifies one or more ports or slots and ports. On a modular switch, can be a

list of slots and ports. On a stand-alone switch, can be one or more port

numbers. May be in the form 1, 2, 1:2, 3-5.

Specifies an interface: 1 or 2.

Specifies the power level for the interface. Valid values are:

Min (minimum)

configure wireless port interface power-level

ExtremeWare Software 7.3.0 Command Reference Guide

Extremeware 7.3.0