Configure Ports T3 Framing - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

T1, E1, and T3 WAN Commands

configure ports t3 framing

configure ports <portlist> t3 framing [c-bit | m13]

Configure framing for a T3 link.

Syntax Description

C-Bit framing is enabled by default.

Usage Guidelines

Framing is used to synchronize data transmission on the line. Framing allows the hardware to

determine when each packet starts and ends. The two choices for T3 framing are C-Bit and M13.

The following command sets framing to M13 for the T3 port:

configure ports 3:1 t3 framing m13

This command was first available in ExtremeWare v6.1.8w3.0.1b61 WAN technology release.

This command was subsequently incorporated into ExtremeWare 7.0.0.

Platform Availability

This command is available on the Alpine 3800 series platform, when a WAN module is installed.

A list of ports.

Specifies C-Bit framing.

Specifies M13 framing.

ExtremeWare Software 7.3.0 Command Reference Guide

Extremeware 7.3.0