Configure Wireless Ports Interface Wireless-Bridging - Extreme Networks ExtremeWare Command Reference Manual

configure wireless ports interface wireless-bridging

configure wireless ports <portlist> interface [1 | 2] wireless-bridging [on
| off]
Description
Enables or disables the interface as a bridge for wireless clients.
Syntax Description
portlist
interface
on
off
Default
On (enabled).
Usage Guidelines
Wireless bridging on Alpine 3800 switches allow wireless users within the same VLAN to communicate
with other wireless users on the same switch using layer 2 bridging. Wireless bridging can be enabled
or disabled for each interface of the wireless port, and the setting is locally significant on each Altitude
300 wireless port. This setting does not prevent bridging between wired and wireless MAC addresses in
the same VLAN or between remote wireless stations associated with a remote Altitude 300 wireless
port.
Example
The following command disables bridging interface 2 on port 1:15:
configure wireless port 1:15 interface 2 wireless-bridging off
History
This command was first available in ExtremeWare 6.2a and added to the "i" series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
Specifies an interface: 1 or 2.
Specifies that the indicated interface is enabled. When enabled, wireless
clients on the same interface are able to communicate.
Specifies that the indicated interface is disabled. When disabled, wireless
clients on the same interface cannot communicate.
configure wireless ports interface wireless-bridging
2035