Configure Debug-Trace Ipxrip-Message - Extreme Networks ExtremeWare Command Reference Manual

configure debug-trace ipxrip-message

configure debug-trace ipxrip-message <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
Syntax Description
debug level
vlan name
Default
The default level is 0.
Usage Guidelines
The
debug level
the messages recorded at lower levels.
Example
The following command sets the reporting level for IPX RIP message errors to 4:
configure debug-trace ipxrip-message 4
Following is the log output at this level:
<INFO:SYST> serial admin: configure debug-trace ipxrip-message 4 ipxvlan
<INFO:SYST> Log cleared
<INFO:SYST> serial admin: clear log
<DBUG:KERN> 0x0881347d82: 00 03
<DBUG:KERN> 0x0881347d72: 00 02 00 00 36 12 00 01 00 01 00 00 10 69 00 02
****6********i**
<DBUG:XRIP> Sending Rsp msg to f0001964:ff:ff:ff:ff:ff:ff len 18
<DBUG:XRIP> Added entry net 1069 hops 2 ticks 3 to rsp
<DBUG:XRIP> Added entry net 3612 hops 1 ticks 1 to rsp
<INFO:EAPS> eaps_runtime.c 1426: State Change, Failed -> Complete, EAPS="man1"
<INFO:EAPS> eaps_runtime.c 277: Primary Port Change, Down -> Up
<INFO:SYST> Port 1:2 link active 1000Mbs FULL duplex
<DBUG:KERN> 0x0881347d82: 00 03
<DBUG:KERN> 0x0881347d72: 00 02 00 00 36 12 00 01 00 01 00 00 10 69 00 02
****6********i**
<DBUG:XRIP> Sending Rsp msg to f0001964:ff:ff:ff:ff:ff:ff len 18
ExtremeWare Software 7.3.0 Command Reference Guide
Specifies a debug level:
0 — None.
1 — None.
2 — Verifies that ipxrip messages are being sent and received.
3 — Verifies the contents of the messages.
4 — Displays a dump of each packet.
5 — No additional information recorded.
Specifies a VLAN name.
range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
configure debug-trace ipxrip-message
**
**
2161