Configure Mpls Vpls - Extreme Networks ExtremeWare Command Reference Manual

configure mpls vpls

config mpls vpls <vpls_name> {vman-id <vman_id>} {mtu <number>}
Description
Configures transmit parameters for packets received on the local VPLS interface as specified by
vpls_name.
Syntax Description
vpls_name
vman-id
number
Default
Priority - 0
ttl_value - 4
number (MTU) - 1500
Usage Guidelines
This command optionally configures transmit parameters for packets received on the local VPLS
interface as specified by
By default, the
specifying the
switch to identify the vpls port list configured for
specified
vman-id
The keyword optionally specifies the MTU value of the VPLS transport payload packet (customer
mtu
packet). The
configured with the same
between VPLS peers. By default the VPLS
9216. Changing the mtu setting will cause established VC-LSPs to terminate. VPLS payload packets may
be dropped if the VPLS MTU setting is greater than the MPLS MTU setting for the VC-LSP interface.
The vplsping command may be used to verify end-to-end path connectivity for specific payload packet
sizes (see VPLS Ping Command on page 3).
Example
Needed
History
This command was first available in an ExtremeWare 7.3.
ExtremeWare Software 7.3.0 Command Reference Guide
Identifies the VPLS within the switch (character string)
Specifies the VLAN ID used internally in the switch to identify the vpls port list
configured for vpls_name.
Specifies the MTU value of the VPLS transport payload packet.
.
vpls_name
is automatically chosen when the vpls is configured, but may be changed by
vman_id
keyword. The
vman-id
cannot conflict with any other configured VLAN ID.
value is exchanged with vpls configured peer nodes. All VPLS peer nodes must be
mtu
value. If the mtu values do not match, VC-LSPs cannot be established
mtu
parameter specifies the VLAN ID used internally in the
vman-id
vpls_name.
is set to 1500. The configurable
mtu
Valid values are 1 through 4096. The
range is 1492 through
mtu
configure mpls vpls
1813