Configure Sonet Framing Ports - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

PoS Commands

configure sonet framing ports

configure sonet framing [sonet | sdh] ports <portlist>

Configures the framing type for the specified SONET ports.

Syntax Description

The default setting is

Usage Guidelines

You can configure each port for framing that complies with either the SONET standard or the SDH

standard. SONET is primarily an American standard; SDH is the international version.

The following command example selects SDH framing for port 1 of the PoS module installed in slot 8 of

the BlackDiamond switch:

config sonet framing sdh ports 8:1

This command was first available in an ExtremeWare IP Technology Services Release based on

Platform Availability

This command is available on the BlackDiamond switch only.

Sets the framing type to SONET.

Sets the framing type to SDH.

Specifies the port number(s).

ExtremeWare Software 7.3.0 Command Reference Guide

Extremeware 7.3.0