Configure Debug-Trace Vrrp-Hello - Extreme Networks ExtremeWare Command Reference Manual

Troubleshooting Commands

configure debug-trace vrrp-hello

configure debug-trace vrrp-hello <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
Syntax Description
debug level Specifies a debug level:
0 — Records critical errors, such as a task crash or an interface down.
1 — Records warning messages, such as incorrect address, incorrect protocol, and
2 — Records information such as VLAN, VRID, priority, auth-type, advert-interval, and
3 — Records the same information recorded in level 2, with more detail.
4 — Displays a dump of each packet.
5 — No additional information recorded.
vlan name Specifies a VLAN name.
Default
The default level is 0.
Usage Guidelines
The range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
debug level
the messages recorded at lower levels.
Example
The following command sets the reporting level for VRRP hello messages to 4:
configure debug-trace vrrp-hello 4
Following is the log output at this level:
<DBUG:SYS > Vlan=Default: vrrpTransmit: vrid=1,pri=255,cnt_ip_addr=1,auth_type=0
advert=1,ipaddr=10.45.208.10
<DBUG:SYS > Vlan=Default: vrrpTransmit: vrid=1,pri=255,cnt_ip_addr=1,auth_type=0
advert=1,ipaddr=10.45.208.10
<DBUG:SYS > Sending vrrp-pkt(0x8313d630) len 40 to 224.0.0.18 if rif0,
mac=00:00:5e:00:01:01
<DBUG:KERN> <--- Start of chain (84859200) --->
<DBUG:KERN> m0 @ 0x84859200:
<DBUG:KERN> 0x0884859214: 00 00 00 28 00 00 00 00 ff 70 00 00 00 00 00 00
***(*****p******
<DBUG:KERN> 0x0884859224: e0 00 00 12 21 01 ff 01 00 01 05 c4 0a 2d d0 0a
****!********-**
<DBUG:KERN> 0x0884859234: 00 00 00 00 00 00 00 00 ********
<DBUG:KERN> <--- End of chain (84859200) --->
2198
failed checksum.
IP address.
Length=40 m_off=20 m_data=0x84859214
ExtremeWare Software 7.3.0 Command Reference Guide