Configure Sonet Threshold Signal Degrade Ports - Extreme Networks ExtremeWare Command Reference Manual

configure sonet threshold signal degrade ports

configure sonet threshold signal degrade <error_rate> ports <portlist>
Description
Configures the signal degrade threshold for the specified SONET ports.
Syntax Description
error_rate
portlist
Default
The default is 10
Usage Guidelines
A signal degrade (SD) event is generated if the bit error rate (BER) for the SONET line exceeds the
configured threshold. If automatic protection switching (APS) is enabled on the port, a SD event will
initiate a line switch. The
10-
error_rate
or 1 per million.
Example
The following command example sets the Signal Degrade threshold value to
module installed in slot 8 of the BlackDiamond switch:
config sonet threshold signal degrade 8 ports 8:1
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only.
ExtremeWare Software 7.3.0 Command Reference Guide
Sets the threshold for the bit error rate for the SONET line.
Specifies the port number(s).
-6 .
parameter is an integer in the range [5-9], where the SD BER is
error_rate
. The default value of the parameter is 6, which equates to a SD BER of 10
error_rate
configure sonet threshold signal degrade ports
for port 1 of the PoS
8
-6 ,
1669