Configure Flowstats Filter Ports - Extreme Networks ExtremeWare Command Reference Manual

configure flowstats filter ports

configure flowstats filter <filter#> {aggregation} {export <group#>} ports
<portlist> [ingress | egress] <filterspec>
Description
Configures a flow record filter for the specified SONET ports.
Syntax Description
filter#
aggregation
export <group# tn
portlist
ingress
egress
filterspec
Default
By default, filter#1 is configured to
match-no-flows
ExtremeWare Software 7.3.0 Command Reference Guide
The filter# parameter is an integer in the range from 1 to 8 that operates
with either the ingress or egress keyword to identify the filter that is being
defined.
Reduces the volume of exported data, use this optional keyword to maintain a
single set of statistics for all the flows that match the specified filter.
Specifies a particular export distribution group on a per-filter basis. Identifies
the set of flow collector devices to which records for flows matching the filter
are to be exported.
Specifies the port number(s).
Use this keyword to specify that the filter being defined in the command is one
of the eight filters to be applied to ingress flows.
Use this keyword to specify that the filter being defined in the command is one
of the eight filters to be applied to egress flows.
Each filter is defined using a value/filtermask pair for each of the five
components in the following sequence:
{des tination IP address, source IP address,
destination port number, source port number, protocol}
in the form:
[{dest-ip <ipaddress_value/ipaddress_filtermask>}
{source-ip <ipaddress_value/ipaddress_filtermask>}
{dest-port <port_value/port_filtermask>}
{source-port <port_value/port_filtermask>}
{protocol <protocol_value/protocol_filtermask>} |
match-all-flows | match-no-flows]
The ipaddress_filtermask, port_filtermask, and
protocol_filtermask parameters are configured using hexadecimal
notation.
You can also use either the match-all-flows keyword or the
match-no-flows keyword in place of settings for the five components. The
match-all-flows keyword adjusts the value/filtermask settings for all the
components to 0/0 such that the filter matches any flow. The
match-no-flows keyword adjusts the value/filtermask settings for all the
components such that the filter does not match any flow.
match-all-flows
. The defaults to 1 if the parameter is omitted.
group#
, and the remaining filters are configured to
configure flowstats filter ports
1647