Configure Ppp Authentication Ports - Extreme Networks ExtremeWare Command Reference Manual

configure ppp authentication ports

configure ppp authentication [off | chap | pap | chap-pap] ports <portlist>
Description
Configures authentication on the specified PPP ports.
Syntax Description
off
chap
pap
chap-pap
portlist
Default
The default is authentication
Usage Guidelines
When is specified, the peer is not authenticated. When
off
using the challenge handshake authentication protocol (CHAP). When
authenticated via the password authentication protocol (PAP). Specification of
either CHAP or PAP may be used to authenticate the peer.
Example
The following command example turns on CHAP authentication for port 1 of the PoS module installed
in slot 8 of the BlackDiamond switch:
config ppp authentication chap ports 8:1
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only. A similar command is available on the
Alpine switch.
ExtremeWare Software 7.3.0 Command Reference Guide
Disables authentication
Authenticates the peer using the challenge handshake authentication protocol
(CHAP).
Authenticates the peer using the password authentication protocol.
Specifies that either CHAP or PAP may be used to authenticate the peer.
Specifies the port number(s).
.
off
configure ppp authentication ports
is specified, the peer is authenticated
chap
is specified, the peer is
pap
chap-pap
indicates that
1653