Configure Ports T1 Cablelength - Extreme Networks ExtremeWare Command Reference Manual

configure ports t1 cablelength

configure ports <portlist> t1 cablelength [[0 | -7.5 | -15 | -22.5] db |
[133 | 266 | 399 | 533 | 655] feet]
Description
Control T1 transmitter signal level for different cable lengths.
Syntax Description
portlist
feet
db
Default
The default setting is 133 feet.
Usage Guidelines
For short haul connections (less than 1000 feet) the transmitter level for T1 is set by selecting a cable
length in feet, from the following values: 133, 266, 399, 533 or 655. Choose the next higher value if the
cable length provided by your service provider does not match one of these values. For example, choose
133 for a 50 foot cable and 533 for a 450 foot cable. The default value is 133, which corresponds to cables
in the range of 0-133 feet.
For longer distances (up to 6000 feet) T1 equipment uses more sensitive receivers, and crosstalk is more
likely to occur. Under these conditions, the transmitter level is set by selecting a transmitter attenuation
level in dB from the following values: -22.5, -15, -7.5, or 0.
From lowest to highest transmitter level, use the following values for the
cablelength
Example
The following command sets the cablelength for all T1 ports:
configure ports 2:1-2:4 t1 cablelength 533 feet
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when the applicable WAN module is
available.
ExtremeWare Software 7.3.0 Command Reference Guide
A list of ports.
Specifies the cable length in feet. Only the values above are allowed.
Specifies the transmitter attenuation in decibels. Only the values above are
allowed.
command: -22.5 db, -15 db, -7.5 db, 0 db, 133 feet, 266 feet, 399 feet, 533 feet, and 655 feet.
configure ports t1 cablelength
configure port t1
1703