Ipaddrshow - Brocade Communications Systems StoreFabric SN6500B Command Reference Manual

ipAddrShow

Displays IP address information for a switch or control processor (CP).
SYNOPSIS
ipaddrshow
ipaddrshow [-cp cp_number] | -chassis
ipaddrshow -slot slot [-eth0 | -eth1 | -gate
DESCRIPTION
Use this command to display the IP addresses configured in the system.
The -cp option displays the IP address for a specified CP on modular platforms, or use the command
without arguments to display the IP address on a standalone switch, or the IP addresses for both CPs on
a chassis.
On a standalone switch, the command displays the following information:
•
•
•
•
•
•
•
•
On modular platforms, the command displays the following information:
For the chassis:
•
•
For each CP:
•
•
•
•
If the IPFC network interface is configured for logical switches:
•
Local IPv6 addresses display the following identifiers:
•
•
Fabric OS Command Reference
53-1002746-01
Ethernet IP Address
Ethernet Subnet mask
The Gateway IP Address
Dynamic Host Control Protocol (DHCP): on or Off
IPv6 Autoconfiguration Enabled: Yes or No
Local IPv6 Addresses
IPv6 Gateway address
DHCPv6: on or off
Ethernet IP Address
Ethernet Subnet mask
Ethernet IP Address
Ethernet Subnet mask
Host Name
Gateway IP Address
IPFC address for Virtual Fabric ID
For each CP:
-
Backplane IP address
-
IPv6 Autoconfiguration Enabled: Yes or No. If enabled, the command displays:
 All local IPv6 Addresses
 Gateway IP addresses for both CPs
IP Address type:
-
static - A statically configured IPv6 address.
-
stateless - Acquired through stateless autoconfiguration.
IP Address state:
2
ipAddrShow
469