Brocade Communications Systems StoreFabric SN6500B Command Reference Manual page 831

mgmtif
mgmtroute
xtun
Fabric OS Command Reference
53-1002746-01
-q | --qos
Displays the QoS statistics including performance for each priority. This operand
is optional with the --perf option.
Displays the inband management interfaces configured for a specified GbE Port
or for all GbE Ports. For each GbE Port, the display includes the interface status
(enabled or disabled), the interface IPv4 Address, the netmask, effective MTU,
and annotated port flags.
Displays the management routes configured for a specified GbE Port or for all
GbE Ports. For each GbE Port, the display includes the destination IPv4 Address,
the netmask, the gateway address, and annotated port flags. The metric field is
not valid for the Brocade 7800.
Displays FICON and FCP emulation statistics and current runtime conditions for a
specified set of parameters. The following arguments are supported:
-fcp
Displays the SCSI FastWrite/Tape Pipelining command sub-menu when issued
with a VE_Port number. The syntax for -fcp is as follows:
portshow xtun [slot/]\ve_port -fcp [level] [command] [param] [options]
The following optional operands are supported with -fcp to display FCP emulation
statistics and status information:
-help
Displays the command usage. You must specify a VE_Port number to display
the help functions, for example: portshow xtun 7/12 -fcp -help.
level
Specifies the level for which information is displayed. You can specify one or
more of the following levels. With each additional level, this command
generates progressively more information.
-port
Displays data at the port level.
-it
Displays data at the Initiator Target (SID/DID) FCP level.
-itn
Displays data at the Initiator Target nexus (SID/DID) level.
-itl
Displays data at the Initiator Target LUN (SID/DID/LUN) level.
-twb
Displays data at the Exchange (SID/DID/LUN/Exchange) level.
command
Specifies the type of information to be displayed. This operand is optional; if
omitted, the default (-stats) is used. You can specify more than one
command option. Valid commands include the following:
-stats
Displays FCP emulation statistics. This is the default display.
-info
Displays general FCP emulation information.
-cfg
Displays the FCP emulation configuration.
2
portShow
803