Brocade Communications Systems StoreFabric SN6500B Command Reference Manual page 218

2
cryptoCfg
EXAMPLES
To create an encryption group "brocade":
To create an encryption group "brocade" on a node that has stale configurations:
To delete the encryption group "brocade":
To register a NetApp LKM appliance as the primary key vault "LKM1":
To set the key vault type to LKM:
To add a member node to the encryption group:
To eject a member node from the encryption group:
To leave the encryption group:
190
-rx
Displays receiver throughput.
-tx -rx
Displays transmitter and receiver throughput.
-t interval
Specifies the time interval,in seconds, between refreshes.
SecurityAdmin:switch> cryptocfg --create -encgroup brocade
Encryption group create status: Operation Succeeded.
SecurityAdmin:switch> cryptocfg --create -encgroup brocade
Warning: There are stale (Container|HA|Tape) cryptodb configurations.
Please confirm to delete them.
ARE YOU SURE (yes, y, no, n): [no] y
Warning: These are the list of
to be cleaned up:
Inside /etc/fabos/mace (crypto_dek.db.0, crypto_dev.db.0, \
crypto_hac.db.0, crypto_pool.db.0, crypto_wwn.db.0).
ARE YOU SURE (yes, y, no, n): [yes]y
Encryption group create status: Operation Succeeded.
SecurityAdmin:switch> cryptocfg --delete -encgroup brocade
Encryption group create status: Operation Succeeded.
SecurityAdmin:switch> cryptocfg --reg -regkeyvault
LKM1 lkmcert.pem 10.33.54.231 primary decru-lkm-1
Register key vault status: Operation Succeeded.
SecurityAdmin:switch> cryptocfg --set -keyvault LKM
Set key vault status: Operation Succeeded.
SecurityAdmin:switch> cryptocfg --add -membernode
10:00:00:05:1e:39:14:00
Add node status: Operation Succeeded.
SecurityAdmin:switch> cryptocfg --eject -membernode
10:00:00:05:1e:53:b8:45
Eject node status: Operation Succeeded.
SecurityAdmin:switch> cryptocfg --leave_encryption_group
Leave node status: Operation Succeeded.
crypto configuration \
\
\
\
Fabric OS Command Reference
53-1002746-01