Portcfgnport - Brocade Communications Systems StoreFabric SN6500B Command Reference Manual

2

portCfgNPort

portCfgNPort
Enables or disables N_Port functionality for an Access Gateway port.
SYNOPSIS
portcfgnport [slot/]port1[-port2] [mode]
DESCRIPTION
Use this command to enable or disable N_Port functionality for an Access Gateway port or for a range of
ports. The enabled N_Ports automatically come online if they are connected to an enterprise fabric
switch that supports NPIV. When used without operands, this command displays the port configuration.
NOTES
NPIV capability must be enabled on the ports connected to the Access Gateway. By default, NPIV is
enabled. Use portcfgnpivport --enable to enable NPIV capability on a port, if it was previously disabled.
Note that enabling or disabling NPIV capability is no supported in Access Gateway mode.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following optional operands:
slot
port1[-port2]
mode
EXAMPLES
To enable N_Port functionality for a port:
To enable N_Port functionality for a set of ports in a specific range:
To display the N_Port configuration for all ports:
SEE ALSO
portCfgShow,
696
Specifies the slot number, followed by a slash (/) on bladed systems.
Specifies a single port or a range of ports to be configured as N_Ports, for
example, 3-9, or 2/10-15.
Enables (1) or disables (0) N_Port functionality on the specified ports. The default
mode is 0 (disabled).
switch:admin> portcfgnport 8 1
switch:admin> portcfgnport 2-3 1
switch:admin> portcfgnport
Ports
--------------------+--+--+--+--+--+--+--+--+--+--+--+- [...]
Locked N_Port
switch:admin> portcfgshow
Ports of Slot 0 0
----------------+--+--+--+--+---+--+--+--+---+--+--+--+---+--+--+---
Speed AN AN AN AN
Fill Word(On Active)0 0
Fill Word(Current )0
Trunk Port ON ON ON ON
Locked N_Port .. .. ON ON .. .. .. ..
Persistent Disable.. .. .. ..
(output truncated)
ag
0 1 2 3 4 5 6
.. .. ON ON .. .. .. .. ON .. ..
1 2 3 4 5 6 7
AN AN AN AN
0 0 0 0 0 0
0 0 0 0 0 0 0
ON ON ON ON
.. .. .. ..
7 8 9 10 [...]
[...]
8 9 10 11 12 13 14 15
AN AN AN AN AN AN AN AN
0 0 0 0 0 0
0 0 0 0 0 0
ON ON ON ON ON ON ON ON
.. .. .. .. .. .. .. ..
.. .. .. .. .. .. .. ..
Fabric OS Command Reference
0 0
0 0
53-1002746-01