Portcfglosstov - Brocade Communications Systems StoreFabric SN6500B Command Reference Manual

portCfgLossTov

Enables or disables de-bouncing of signal loss for front end ports.
SYNOPSIS
portcfglosstov [slot/]port mode
DESCRIPTION
Use this command to enable or disable the de-bouncing of loss of signal for 100 ms for front end ports.
Use portCfgShow to display the current setting.
If executed without operands, the command prints the usage.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
On a chassis, this command must be executed on the active CP.
OPERANDS
This command has the following operands:
slot
port
mode
EXAMPLES
To enable the configuration on port 1/5 and to display the configuration:
To disable the configuration on port 1/5:
SEE ALSO
portCfgShow
Fabric OS Command Reference
53-1002746-01
For bladed systems only, specifies the slot number of the port to be configured,
followed by a slash (/).
Specifies the port to be configured, relative to its slot for bladed systems. Use
switchShow to list valid ports.
Specify 1 to enable the configuration. Specify 0 to disable the configuration.
switch:admin> portcfglosstov 1/5 1
switch:admin> portcfgshow 1/5
Area Number:
Speed Level:
Fill Word(On Active):
Fill Word(Current):
AL_PA Offset 13:
Trunk Port
Long Distance
VC Link Init
Locked L_Port
Locked G_Port
Disabled E_Port
Locked E_Port
ISL R_RDY Mode
RSCN Suppressed
Persistent Disable
LOS TOV enable
(Output truncated)
switch:admin> portcfglosstov 1/5 0
5
AUTO(HW)
0(Idle-Idle)
0(Idle-Idle)
OFF
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
2
portCfgLossTov
689