Hasyncstart - Brocade Communications Systems StoreFabric SN6500B Command Reference Manual
Brocade fabric os command reference v7.1.0 (53-1002746-01, march 2013)
Hide thumbs
Also See for StoreFabric SN6500B:
- User manual (1505 pages) ,
- Reference (934 pages) ,
- Reference manual (370 pages)
Table of Contents
Advertisement
2
haSyncStart
haSyncStart
Enables High Availability state synchronization.
SYNOPSIS
hasyncstart
DESCRIPTION
Use this command to enable the High Availability (HA) state synchronization.
After issuing haSyncStop, the switch does not go back to sync start unless you perform one of the
following actions: reboot the active CP, reboot the standby CP, insert a new standby CP (blade), or issue
the haSyncStart command The time it takes for the HA sync to complete depends on the system
configuration. The HA sync timeout is set to 10 minutes.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
EXAMPLES
To enable the HA state synchronization:
SEE ALSO
haFailover, haShow,
438
switch:admin> hasyncstart
haSyncStop
Fabric OS Command Reference
53-1002746-01
- Quick Links:
- Alicreate
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the StoreFabric SN6500B and is the answer not in the manual?