Brocade Communications Systems StoreFabric SN6500B Command Reference Manual page 754

2
portCmd
VLAN tagging ensures that test traffic traverses the same path as real FCIP traffic. A VLAN tag entry
must exist prior to issuing the --ping or --traceroute commands; this includes both the local and remote
sides.
NOTES
The -crc option to portCmd --tperf is no longer supported as of Fabric OS v7.0.0.
End-to-end path characterization is not supported if an IPSec-enabled tunnel exists that uses the same
source/local IP address.
Make sure to use the --ping command with a double-dash (--). If the dashes are omitted, a message
displays indicating that the command is deprecated.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
slot
ge port
--ping
726
For bladed systems only, specifies the slot number of the port to be configured,
followed by a slash (/).
Specifies the port number of the GbE port on the blade.
Pings a destination IP address from one of the source IP interfaces on the GbE
port. Valid arguments and their values include the following:
-s src_ip
Specifies the source IP address that originates the ping request. IPv6 addresses
are supported.
-d dst_ip
Specifies the destination IP address to which to target the ping request. IPv6
addresses are supported.
-x | -crossport
Specifies the source IP address as a crossport. A crossport is the nonlocal
(secondary) XGE port to a VE_Port group that provides failover capabilities for the
tunnel configured on the local XGE port. This operand is optional and supported
only on the Brocade FX8-24 XGE ports.
-n num_requests
Specifies the number of ping requests. Valid values are 1 to 255. The default is 4.
This operand is optional.
-q service_type
Specifies the type of service in the ping request. The default is 0 and service_type
must be an integer from 0 to 255. This operand is optional.
-t ttl
Specifies the time to live. Valid values are 1 to 255. The default is 100. This
operand is optional.
-w wait_time
Specifies the time to wait for the response of each ping request in milliseconds.
The default is 5000 ms and the maximum wait time is 9000 ms (9 seconds). This
operand is optional.
Fabric OS Command Reference
53-1002746-01