Brocade Communications Systems StoreFabric SN6500B Command Reference Manual page 758

2
portCmd
To verify if packets can be sent to the destination IP address using VLAN tagging with the -c option.
To trace the IP router hops used to reach the remote host using VLAN tagging with the -c option.
To ping a failover crossport:
To trace the route to a failover crossport:
To set the path characteristic to source mode on the remote host using VLAN tagging with the -c option.
To create a TPerf data sink on VE_Port 16:
To configure a Brocade FX8-24 blade as a TPerf data source (this example generates round-trip high,
medium, and low priority traffic with a fixed PDU size of 2084 bytes. The payload pattern is a jitter pattern
and the checksum is checked by the sink):
730
switch:admin> portcmd --ping 8/ge0
-s 192.168.10.1 -d 192.168.20.1 -v 10 -c 3
switch:admin> portcmd --traceroute 8/ge0
-s 192.168.10.1 -d 192.168.20.1 -v 10
switch:admin> portcmd --ping 8/xge0
192.168.11.20 -d 1.1.1.1 -x
switch:admin> portcmd --traceroute 8/xge0
192.168.11.20 -d 1.1.1.1 -x
switch:admin> portcmd --ipperf 8/ge0
-s 192.168.10.1 -d 192.168.20.1 -S -v 10 -c 3
switch:admin> portcmd --tperf 16 -sink
TPerf has been configured successfully for 16
TPerf is servicing requests on 16
TPerf is servicing requests on 16
TPerf is servicing requests on 16
Tperf data source can now be started
switch:admin> portcmd --tperf 16 -source
-size 2048 -pattern 5
TPerf has been configured successfully for 16
TPerf is generating traffic on 16
***************************************************************
Tunnel ID: 16
bytes tx
bytes rx
PDUs tx
PDUs rx
out of seq PDUs rx
flow control count
last rtt
***************************************************************
\
\
\
priority: high
priority: medium
priority: low
priority: medium
High Priority Medium Priority Low Priority
0 5280520
0 407240
0 10183
0 10182
0 0
0 0
0 5
\
\
\
0
0
0
0
0
0
0
Fabric OS Command Reference
53-1002746-01